![]() It just needs to be *snug* if you’re using blue loctite. About 8-10 INCH pounds, not a lot or you’ll strip the screw heads. Note 3: We highly recommend removing one screw at a time once all are tight, applying blue loctite, then re-tightening. Slide rail onto the rifle starting at the REAR of the rail from in FRONT of the flash hider all the way down until the rear stays’ U-shaped cups are around the mounting points of the rifle receiver. DO NOT used a round nose punch, you will mar the threads and the screws won’t insert. About 5-7 minutes with slow, deliberate, firm hammer strikes on the brass punch. Note 2: Use a FLAT brass punch to hammer the standoff in. The screws are long enough to allow the rail to be drawn tight towards the stay. Note: The silver standoff will NOT be flush with the front stay edges. Simply oil the silver standoff and the holes on the U-shaped stay, line up the front stay and the gas block holes, and hammer the silver standoff into the holes until equally inserted left and right. This creates an interference fit like an AR roll pin to eliminated the wobble the factory plastic handguard has and gives you a tight fit on your rifle. ![]() DO NOT SAND THE STANDOFF OR REAM THIS HOLE. The front U-shaped stay hole is DELIBERATELY oversized. Remove these screws while noting their position and set aside. ![]() We insert the screws into the u-shaped front stay and silver aluminum standoff to mark where they go as they are differently sized. The front U-shaped stay goes around your factory gas block and the. It’ll be in the plastic of the rail but might fall into packaging material. There is a small baggie with your front stay, internally-threaded standoff, and screws for the front mount. We pre-assemble these with the exception of ONE pin that has to be assembled. Installation instructions will NOT be in the box. Thanks again for all your business, we greatly appreciate it! Yes, we ship to Canada, but no other international shipping due to ITAR. These mount the exact same way with the exact same hardware as the original Raptor rail, so it will be a slip-on replacement. Powder coated black, this will also be offered in tan and green once we get them back from Cerakote.įor those who have purchased a Raptor Rail, we will be offering an exchange on your rails as well, price depending on condition. Squared off at the front instead of angled, this is the same overall length as the original Raptor rail, but due to being squared off at the front adds one M-Lok section on the left, right, and top sides for accessory mounting or better hand gripping. ![]() This is the long-awaited 2nd version of the 6061-T6 aluminum handguard for the Kel-Tec RDB.Īfter many requests, we have created a 2nd version we call the “Rhino Rail”. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |